BDL Action Screw Set for Remington 700 - Black

The original hardware for my Remington 700 30-06 did not line up with the Magpul Hunter 700L stock. The front action screw was too short and the rear screw was only holding by two threads. These new ones I received today are a direct fit for the Magpul stock.

Excellent product, great communication and lighting fast shipping will defintely be back for more

These where a perfect fit for my magpul hunter stock!
Where the original action screws from my 700 where barely in by a couple thread's these had just enough to secure it with plenty of thread for proper inch pounds

Fit very well

Exactly what I ordeed

I had to grind them down with a grinder wheel because my gun wouldn’t work without doing it, bolt wouldn’t open that is. No big deal, 5 minutes later it was good to go.

Perfect fit

Screw quality is much better then the factory. That being said the front screw I replaced was longer then my factory screw by two threads. This isn't a bad thing as you get to fit the screw precisely to your gun. Just get two 1/4x28 nuts thread in the screw and set the nuts to the depth that needs to be taken off. Lock nuts together and put in a vice. Use a file and take off the amount needed.. level to the top of nut. Unlock nuts and screw the nuts down ,bevel the screw and check that it does bind on the nut. If all is right install new screw.

Beautiful, Just like factory. A bit too long for my aftermarket stock and bottom metal but long is easier to fix than short. Fast delivery with tracking

Moving a 700 ADL to a Magpul Hunter stock, the original ADL action screws were too short, these were the perfect length and required no filing or fitting at all. Exactly what I needed.